Flycolor Raptor Tower 390 w/ F390 30A 4in1 ESC (F3/OSD/PDB) for X Racing Frame

118820 Flycolor Raptor Tower 390 w/ F390 30A 4in1 ESC (F3/OSD/PDB) for X Racing Frame

Flycolor Raptor 390 tower is an integrated 4 in 1 30A ESC, F3 flight controller, OSD and PDB combined and sandwiched together. Lightweight at only 22g and with a height of 15.1mm and designed to suit a drone wheelbase from 130~330mm.
The two-layered structure is made up of a flight controller board bolted to the PDB and ESC board, compact and convenient and decreases the interference caused by signal transmissions. With the ESC’s protected in the center of the lower board means, there is less risk of damaging an ESC when racing or clipping a gate or hitting a tree. Solder tabs for power and motor connections are positioned on the edge of the board for a precise clean and tidy build.
The upper board houses the F3 flight controller integrated with an OSD, there is also a 5V/12V and BATV for powering your VTX, camera, LEDS and other equipment.
Small size, Lightweight, powerful and easy installation combined to make this an awesome edition to your drone racing set up.

Features:
• Two-layer structure 
• Integrated 4 in 1 30A ESC, PDB and F3 Flight controller and OSD 
• Compact and lightweight
• Very easy to install 
• Tidy and clean build due to location of solder tabs
• ESC protected from damage
• Suitable for 120-330mm wheelbase multirotor frame kit, especially for X and Monster DIY frame kit
• Hardware, cables and silicone power wire with xt60 connector

Specs:
Model: Raptor 390 Tower w/ 4 in 1 30A ESC
Continuous current: 30A
Peak current: 40A
BEC: No
Lipo cells: 2~4S
Weight: 22g
Dimensions: 41.5 x 36 x 15.1mm

Included:
1 x Raptor 390 4 in 1 ESC
1 x F3 Flight controller
4 x Nylon spacers M3 5mm 
8 x M3 nuts
4 x Nylon screws M3 x 12
All connecting cables and power wire with XT60 connector

Regular Price:
$70.30

Special Price:
$59.99

VRC 468x90 Flycolor Raptor Tower 390 w/ F390 30A 4in1 ESC (F3/OSD/PDB) for X Racing Frame

Leave a Reply